Referencias: 405 - 406

High-efficiency wall materal based on technogenic aluminosilicate rawmaterials -- modernization ofthe mill's working bodies for the production of fine building materials -- Using of citrogypsum in alkali activated systems -- Efficiency if stabilization of sandy, coarse-grained and technologenic soils with polymer complexes and surfactants of structural layers of highways -- Investigation of gas release processes in a polymer composite filled with amorphous boron under thermal and radiation exposure -- Obtaining energy efficiente polymer-birumen binders using polymer-bitumen binders using polymer-bitumen concentrate -- Effect of cyclic loading level on elastic-strength characteristics and kinetics of damage accumulation in polymers -- Research methods for flame retardant and constructuon and technological properties of protective cnstruction and technological properties of protective coatings -- Methodology for the selectión of optimal parameters of the finite element mesh in compsite materials calculation -- Review study of recycled aggregate concrete coumn under eccentric loading -- Surface modification of ZrH2 with an organosilicon oligmer -- Formation of copper coating on the surface of titanium hydride using quadruple magnetron sputtering -- Investigating of the residual stresses during the extraction of a polymer product from an extruder -- Compatibility of polymer and plsticizer-as a key factor in the formation of degradation-resistant bituminous binder -- Improving the method of assessing the bearing capacity of complex technical systemms -- Optimization o foam fiber concrete mix desing by mathematical modeling -- Analysis of intermdiates produced during the synthesis of Alkyd resins -- Surface structure of modified titanium hydride fraction -- Optimization of paramenters for the production of gypsum binders based on gypsum-containing waste -- Heat-shielding properties of concrete structures reinforced with composite reinforcement -- Eosive wear of alumina coated plyimide composite -- Biological and climatic resistance of cement composites based on biocidal binders -- calculation of the parameters of the grinding load in a ball-tube mill for the production of construction materials -- Dynamic behavior of an "earth dam-foundation" plane system within wave theory -- Effect of plasma blast furnace slag treatment on properties of blast furnace slag-cement mortar -- Mechanical, tribological, and anticorrosion properties of the coating produced by magnetron sputtering of a Ni-Cr-B4C compsite target -- Corretation of bitumen emulsion stability factor with aqueous phase parameters evaluated at the stage of composition design -- Electrochemical co-depsition of copper and nanodispersed tungsten carbide on titanium hydride -- Light-colored ceramic products from red-burning clay raw materials -- On the effect of operating conditions on the coupling of non-metallic external reinforcement with reinforced concrete structure -- Research study of mixing processes in the pneumatic mixer for dry construction mixes -- Improving the calculation of variable cross section compressed wooden bars stability -- Characterization of a polymer composite withs a hybrid filler -- Finite element modling of the work of bent reinforced concrete elements of rectangular section in the abaqus software environment -- Clay-slag autoclaved composite material with the usage of activated aluminosilicate raw materials -- cellular concrete mixes with bentonite suspension -- Foundation type influence on the construction site seismicity -- model of the catastrophic stage of wood damage accumulation under uniaxial compression -- Improving the opertional reliability of complex technical systems operting in corrosive conditions -- Power calculation of ball-tube mill drives in the construction materials industry -- Calculation of reliability of beam with corrugated wall with limited information about the controlled parameters at the stage of operation -- White cement clinker roasting intensification -- The influence of electric current on the water separation of cements -- Analysis of the effect of cyclic loading mode on the change in the properties of polymer materials -- Mofification of properties and study of electrical conductivity of citrogypsum -- Improving the quality of building materials due to the effect of shear deformation on the parameters of the grinding process -- Water-resistant clay and slag coposite material of autoclaved hadening -- The study of the patterns of soil contact with a solid suface -- Stress-strain state simulation for the eccentrically compressed reinforced concrete columns with local prestress at the manufacturing stage -- Filled plyurethane foam with improved qulity indicarors -- Autror index.